---

Section I.Chemical Product and Company Identification
    Chemical Name Di-n-octyl Sebacate
    Portland OR
    Synonym        Decanedioic acid, 1,10-diisooctyl ester (CA INDEX    
    NAME);
    Decanedioic Acid Di-n-octyl Ester;
    Di-n-octyl Decanedioate;
    Sebacic Acid Di-n-octyl Ester
    Chemical Formula        C26H50O4    
    CAS Number        14491-66-8    

---

Section II.        Composition and Information on Ingredients    
    Chemical Name        CAS Number Percent (%)        TLV/PEL        Toxicology Data    
    Di-n-octyl Sebacate        14491-66-8 Min. 95.0 (GC) Not available.        Not available.    

---

Section III. Hazards Identification
    No specific information is available in our data base regarding the toxic effects of this material for humans. However,
    Acute Health Effects
    exposure to any chemical should be kept to a minimum. Skin and eye contact may result in irritation. May be harmful if
    inhaled or ingested. Always follow safe industrial hygiene practices and wear proper protective equipment when handling
    this compound.
    Follow safe industrial hygiene practices and always wear proper protective equipment when handling this compound.
    CARCINOGENIC EFFECTS : Not available.
    Chronic Health Effects
    MUTAGENIC EFFECTS : Not available.
    TERATOGENIC EFFECTS : Not available.
    DEVELOPMENTAL TOXICITY: Not available.
    Repeated or prolonged exposure to this compound is not known to aggravate existing medical conditions.

---

Section IV.        First Aid Measures    
    Eye Contact        Check for and remove any contact lenses. In case of contact, immediately flush eyes with plenty of water for at least 15    
    minutes. Get medical attention.
    Skin Contact        In case of contact, immediately flush skin with plenty of water. Remove contaminated clothing and shoes. Wash clothing    
    before reuse. Thoroughly clean shoes before reuse. Get medical attention.
    Inhalation        If the victim is not breathing, perform mouth-to-mouth resuscitation. Loosen tight clothing such as a collar, tie, belt or    
    waistband. If breathing is difficult, oxygen can be administered. Seek medical attention if respiration problems do not
    improve.
    INDUCE VOMITING by sticking finger in throat. Lower the head so that the vomit will not reenter the mouth and throat.
    Ingestion
    Loosen tight clothing such as a collar, tie, belt or waistband. If the victim is not breathing, perform mouth-to-mouth
    resuscitation. Examine the lips and mouth to ascertain whether the tissues are damaged, a possible indication that the toxic
    material was ingested; the absence of such signs, however, is not conclusive.

---

Section V.        Fire and Explosion Data    
    Not available.
    Flammability        May be combustible at high temperature.        Auto-Ignition    
    Flash Points        Not available.        Flammable Limits        Not available.    
    Combustion Products        These products are toxic carbon oxides (CO, CO2).    
    Fire Hazards
    Not available.
    Risks of explosion of the product in presence of mechanical impact: Not available.
    Explosion Hazards
    Risks of explosion of the product in presence of static discharge: Not available.
    Fire Fighting Media        SMALL FIRE: Use DRY chemical powder.    
    LARGE FIRE: Use water spray, fog or foam. DO NOT use water jet.
    and Instructions
    Consult with local fire authorities before attempting large scale fire-fighting operations.
    Continued on Next Page
    Di-n-octyl Sebacate

---

Section VI.        Accidental Release Measures    
    Spill Cleanup        If the product is in its solid form: Use a shovel to put the material into a convenient waste disposal container. If the product is    
    in its liquid form: Absorb with an inert material and put the spilled material in an appropriate waste disposal. Finish cleaning
    Instructions
    the spill by rinsing any contaminated surfaces with copious amounts of water. Consult federal, state, and/or local authorities
    for assistance on disposal.

---

Section VII. Handling and Storage
    Keep away from heat. Mechanical exhaust required. When not in use, tightly seal the container and store in a dry, cool
    Handling and Storage
    place. Avoid excessive heat and light. Do not breathe gas/fumes/ vapor/spray.
    Information
    Always store away from incompatible compounds such as oxidizing agents.

---

Section VIII. Exposure Controls/Personal Protection
    Provide exhaust ventilation or other engineering controls to keep the airborne concentrations of vapors below their respective
    Engineering Controls
    threshold limit value. Ensure that eyewash station and safety shower is proximal to the work-station location.
    Splash goggles. Lab coat. Vapor respirator. Boots. Gloves. Suggested protective clothing might not be sufficient; consult a
    Personal Protection
    specialist BEFORE handling this product. Be sure to use a MSHA/NIOSH approved respirator or equivalent.
    Exposure Limits        Not available.    

---

Section IX. Physical and Chemical Properties
    Liquid. (Clear, colorless.)        Solubility    
    Physical state @ 20°C        Not available.    
    0.91 (water=1)
    Specific Gravity
    Molecular Weight        426.67        Partition Coefficient    
    Not available.
    Boiling Point        225°C (437°F) @ 2 mmHg        Vapor Pressure        Not available.    
    19°C (66.2°F) (freezing point)        14.7 (Air = 1)    
    Melting Point        Vapor Density    
    Refractive Index        Not available.        Volatility        Not available.    
    Not available.        Odorless.    
    Critical Temperature        Odor    
    Viscosity        Not available.        Taste        Not available.    

---

Section X.        Stability and Reactivity Data    

---

This material is stable if stored under proper conditions. (See Section VII for instructions)
    Stability
    Conditions of Instability        Avoid excessive heat and light.    
    Incompatibilities
    Reactive with oxidizing agents.

---

Section XI. Toxicological Information
    Not available.
    RTECS Number
    Eye Contact. Ingestion. Inhalation.
    Routes of Exposure
    Not available.
    Toxicity Data
    Chronic Toxic Effects        CARCINOGENIC EFFECTS : Not available.    
    MUTAGENIC EFFECTS : Not available.
    TERATOGENIC EFFECTS : Not available.
    DEVELOPMENTAL TOXICITY: Not available.
    Repeated or prolonged exposure to this compound is not known to aggravate existing medical conditions.
    No specific information is available in our data base regarding the toxic effects of this material for humans. However,
    Acute Toxic Effects
    exposure to any chemical should be kept to a minimum. Skin and eye contact may result in irritation. May be harmful if
    inhaled or ingested. Always follow safe industrial hygiene practices and wear proper protective equipment when handling this
    compound.
    Follow safe industrial hygiene practices and always wear proper protective equipment when handling this compound.

---

Section XII.        Ecological Information    
    Not available.
    Ecotoxicity
    Not available.
    Environmental Fate
    Continued on Next Page
    Di-n-octyl Sebacate

---

Section XIII. Disposal Considerations
    Waste Disposal        Recycle to process, if possible. Consult your local regional authorities. You may be able to dissolve or mix material with a    
    combustible solvent and burn in a chemical incinerator equipped with an afterburner and scrubber system. Observe all
    federal, state and local regulations when disposing of the substance.

---

Section XIV. Transport Information
    Not a DOT controlled material (United States).
    DOT Classification
    PIN Number        Not applicable.    
    Proper Shipping Name        Not applicable.    
    Packing Group (PG)        Not applicable.    
    DOT Pictograms

---

Section XV. Other Regulatory Information and Pictograms
    TSCA Chemical Inventory        This compound is ON the EPA Toxic Substances Control Act (TSCA) inventory list.    
    (EPA)
    WHMIS Classification        On DSL    
    (Canada)
    EINECS Number (EEC) 248-333-2
    EEC Risk Statements        Not available.    

---

SECTION 16 - ADDITIONAL INFORMATION
N/A