cas号： 14552-35-3 ，名称：双氢氧化乙二胺铜(II) 的性质/作用/用途-化学加百科

双氢氧化乙二胺铜(II)

双氢氧化乙二胺铜(II) 基本信息
CAS号	14552-35-3	分子式	C2H6CuN2
分子量	121.62800	精确质量	120.98300
PSA	24.06000	LogP	-0.25070

我要卖该产品我要采购该产品

等价的CAS号：

14552-35-3,15727-15-8

充值推广查看更多供应商

基本信息物化性质安全信息毒性 MSDS 结构与计算数据

基本信息展开↓

CAS号：: 14552-35-3
3D弹球模型：: 立即前往扯扯看
分子式：: C2H6CuN2
分子量：: 121.62800
中文名称：: 双氢氧化乙二胺铜(II)
英文名称：: CUPRIETHYLENEDIAMINE
中文别名：: 双氢氧化乙二胺铜(II);
亚乙基二胺铜络合物;
氢氧化双(乙二胺)铜;
双氢氧化乙二胺铜
英文别名：: CUPRIETHYLENEDIAMINE;
Bis(ethylenediamine)copper(II) hydroxide;
Copper ethylenediamine;
CUPRIETHYLENEDIAMINE SOLUTION;
Copper(II)-ethylenediamine complex;
Copper(II)-ethylenediame complex;
Cupriethylenediamine dihydroxide
精确分子量/精确质量：: 120.98300
极性分子表面积/PSA：: 24.06000
油水分配系数/LogP：: LogP值指的是某物质在正辛醇/水两相体系中的分配系数的对数值，反映了物质在油水两相中的分配情况。其中、LogP值越大，说明该物质越亲油；反之，LogP值越小，则说明该物质越亲水。
贝尔斯坦号/MDL：: MFCD00274628
EINECS：: 238-597-7
PubChem：: 24867790
InChI：: The Key: WATCRQGYOIZIHC-UHFFFAOYSA-L

物化性质展开↓

密度：: 1.086 g/mL at 25 °C
沸点：: 119.7ºC at 760mmHg
闪点：: 33.9ºC
其它信息：: 1.       性状：深蓝色液体

2.       密度（g/mL,25/4℃）：1.086

3.       相对蒸汽密度（g/mL,空气=1）：未确定

4.       熔点（ºC）：未确定

5.       沸点（ºC,常压）：未确定

6.       沸点（ºC,5.2kPa）：未确定

7.       折射率：未确定

8.       闪点（ºC）：未确定

9.       比旋光度（º）：未确定

10.    自燃点或引燃温度（ºC）：未确定

11.    蒸气压（kPa,25ºC）：未确定

12.    饱和蒸气压（kPa,60ºC）：未确定

13.    燃烧热（KJ/mol）：未确定

14.    临界温度（ºC）：未确定

15.    临界压力（KPa）：未确定

16.    油水（辛醇/水）分配系数的对数值：未确定

17.    爆炸上限（%,V/V）：未确定

18.    爆炸下限（%,V/V）：未确定

19.    溶解性：未确定

安全信息展开↓

危险类别码：: 34
安全说明：: 26-36/37/39-45
安全标志：: S26:万一接触眼睛，立即使用大量清水冲洗并送医诊治。
S45:出现意外或者感到不适，立刻到医生那里寻求帮助（最好带去产品容器标签）。
:
危险标志：: C: Corrosive;

毒理性展开↓

毒理学数据：

1、急性毒性：主要的刺激性影响：

在皮肤上面：刺激皮肤和粘膜；

在眼睛上面：刺激的影响。

Section 3 - HAZARDS IDENTIFICATION
EMERGENCY OVERVIEW
Causes burns.Corrosive.
Potential Health Effects
Eye:
Contact with eyes may cause severe irritation, and possible eye burns.
Skin:
Causes skin burns.
Ingestion:
May cause severe and permanent damage to the digestive tract. Causes gastrointestinal tract burns.
Inhalation:
May cause severe irritation of the respiratory tract with sore throat, coughing, shortness of breath and delayed lung edema. Causes chemical burns to the respiratory tract.
Chronic:
None

Section 4 - FIRST AID MEASURES
Eyes: Get medical aid immediately. Do NOT allow victim to rub eyes or keep eyes closed. Extensive irrigation with water is required (at least 30 minutes).
Skin:
Get medical aid immediately. Immediately flush skin with plenty of water for at least 15 minutes while removing contaminated clothing and shoes. Wash clothing before reuse. Destroy contaminated shoes.
Ingestion:
Do not induce vomiting. If victim is conscious and alert, give 2-4 cupfuls of milk or water. Never give anything by mouth to an unconscious person. Get medical aid immediately.
Inhalation:
Get medical aid immediately. Remove from exposure and move to fresh air immediately. If not breathing, give artificial respiration. If breathing is difficult, give oxygen. Do NOT use mouth-to-mouth resuscitation.
Notes to Physician:

Section 5 - FIRE FIGHTING MEASURES
General Information:
As in any fire, wear a self-contained breathing apparatus in pressure-demand, MSHA/NIOSH (approved or equivalent), and full protective gear. During a fire, irritating and highly toxic gases may be generated by thermal decomposition or combustion.
Extinguishing Media:
In case of fire, use water, dry chemical, chemical foam, or alcohol-resistant foam.

Section 6 - ACCIDENTAL RELEASE MEASURES
General Information: Use proper personal protective equipment as indicated in Section 8.
Spills/Leaks:
Absorb spill with inert material (e.g. vermiculite, sand or earth), then place in suitable container. Clean up spills immediately, observing precautions in the Protective Equipment section. Avoid generating dusty conditions. Provide ventilation.

Section 7 - HANDLING and STORAGE
Handling:
Keep container tightly closed. Do not get on skin or in eyes. Do not ingest or inhale. Use with adequate ventilation. Discard contaminated shoes.
Storage:
Keep container closed when not in use. Store in a cool, dry, well-ventilated area away from incompatible substances. Corrosives area.

Section 8 - EXPOSURE CONTROLS, PERSONAL PROTECTION
Engineering Controls:
Facilities storing or utilizing this material should be equipped with an eyewash facility and a safety shower. Use adequate ventilation to keep airborne concentrations low.
Exposure Limits CAS# 14552-35-3: Personal Protective Equipment Eyes: Wear appropriate protective eyeglasses or chemical safety goggles as described by OSHA's eye and face protection regulations in 29 CFR 1910.133 or European Standard EN166.
Skin:
Wear appropriate protective gloves to prevent skin exposure.
Clothing:
Wear appropriate protective clothing to minimize contact with skin.
Respirators:
A respiratory protection program that meets OSHA's 29 CFR 1910.134 and ANSI Z88.2 requirements or European Standard EN 149 must be followed whenever workplace conditions warrant respirator use. Wear a NIOSH/MSHA or European Standard EN 149 approved full-facepiece airline respirator in the positive pressure mode with emergency escape provisions.

Section 9 - PHYSICAL AND CHEMICAL PROPERTIES

Physical State: Solid
Color: clear dark blue
Odor: None reported.
pH: Not available.
Vapor Pressure: Not available.
Viscosity: Not available.
Boiling Point: Not available.
Freezing/Melting Point: Not available.
Autoignition Temperature: Not available.
Flash Point: Not available.
Explosion Limits, lower: N/A
Explosion Limits, upper: N/A
Decomposition Temperature:
Solubility in water: soluble in water
Specific Gravity/Density: 1.1000g/cm3
Molecular Formula: C2Cu2H8N2-n
Molecular Weight: 159.148

Section 10 - STABILITY AND REACTIVITY
Chemical Stability:
Stable under normal temperatures and pressures.
Conditions to Avoid:
Excess heat, oxidizers.
Incompatibilities with Other Materials:
Strong oxidizing agents.
Hazardous Decomposition Products:
Nitrogen oxides, carbon monoxide, carbon dioxide, nitrogen.
Hazardous Polymerization: Has not been reported.

Section 11 - TOXICOLOGICAL INFORMATION
RTECS#:
CAS# 14552-35-3 unlisted.
LD50/LC50:
Not available.
Carcinogenicity:
COPPER(II)-ETHYLENEDIAMINE - Not listed by ACGIH, IARC, or NTP.

Section 12 - ECOLOGICAL INFORMATION

Section 13 - DISPOSAL CONSIDERATIONS
Dispose of in a manner consistent with federal, state, and local regulations.

Section 14 - TRANSPORT INFORMATION

IATA
Shipping Name: CUPRIETHYLENEDIAMINE SOLUTION
Hazard Class: 8 (6.1)
UN Number: 1761
Packing Group: II
IMO
Shipping Name: CUPRIETHYLENEDIAMINE SOLUTION
Hazard Class: 8 (6.1)
UN Number: 1761
Packing Group: II
RID/ADR
Shipping Name: CUPRIETHYLENEDIAMINE SOLUTION
Hazard Class: 8
UN Number: 1761
Packing group: II

Section 15 - REGULATORY INFORMATION

European/International Regulations
European Labeling in Accordance with EC Directives
Hazard Symbols: C
Risk Phrases:
R 34 Causes burns.
Safety Phrases:
S 25 Avoid contact with eyes.
S 36/37/39 Wear suitable protective clothing, gloves
and eye/face protection.
S 45 In case of accident or if you feel unwell, seek
medical advice immediately (show the label where
possible).
WGK (Water Danger/Protection)
CAS# 14552-35-3: No information available.
Canada
CAS# 14552-35-3 is listed on Canada's NDSL List.
CAS# 14552-35-3 is not listed on Canada's Ingredient Disclosure List.
US FEDERAL
TSCA
CAS# 14552-35-3 is listed on the TSCA inventory.

SECTION 16 - ADDITIONAL INFORMATION
N/A

分子结构与计算化学数据展开↓

分子结构数据

1、摩尔折射率：无可用的

2、摩尔体积（cm³/mol）：无可用的

3、等张比容（90.2K）：无可用的

4、表面张力（dyne/cm）：无可用的

5、介电常数：无可用的

6、极化率（10^-24cm³）：无可用的

7、单一同位素质量：120.982699 Da

8、标称质量：121 Da

9、平均质量：121.6284 Da

计算化学数据

1.疏水参数计算参考值（XlogP）:无

2.氢键供体数量:6

3.氢键受体数量:6

4.可旋转化学键数量:2

5.互变异构体数量:无

6.拓扑分子极性表面积106

7.重原子数量:11

8.表面电荷:0

9.复杂度:6

10.同位素原子数量:0

11.确定原子立构中心数量:0

12.不确定原子立构中心数量:0

13.确定化学键立构中心数量:0

14.不确定化学键立构中心数量:0

15.共价键单元数量:5

Name:	Copper(II)-Ethylenediamine Complex for Viscosity Determination of Material Safety Data Sheet
Synonym:	None
CAS:	14552-35-3

CAS#	Chemical Name	content	EINECS#
14552-35-3	COPPER(II)-ETHYLENEDIAMINE	100	238-597-7