---

SECTION 1: Identification of the substance/mixture and of the company/undertaking
  Product identifiers
    Product name        : 2-Phthalimidoethanesulfonyl chloride    
    REACH No.        : A registration number is not available for this substance as the substance    
    or its uses are exempted from registration, the annual tonnage does not
    require a registration or the registration is envisaged for a later
    registration deadline.
    CAS-No.        : 4403-36-5    
  Relevant identified uses of the substance or mixture and uses advised against
    Identified uses        : Laboratory chemicals, Manufacture of substances    
  
  

---

SECTION 2: Hazards identification
  Classification of the substance or mixture
  Classification according to Regulation (EC) No 1272/2008
    Skin corrosion (Category 1B), H314
    For the full text of the H-Statements mentioned in this Section, see Section 16.
  Classification according to EU Directives 67/548/EEC or 1999/45/EC
    C Corrosive        R34    
    For the full text of the R-phrases mentioned in this Section, see Section 16.
  Label elements
  Labelling according Regulation (EC) No 1272/2008
    Pictogram
    Signal word        Danger    
    Hazard statement(s)
    H314        Causes severe skin burns and eye damage.    
    Precautionary statement(s)
    P280        Wear protective gloves/ protective clothing/ eye protection/ face    
    protection.
    P305 + P351 + P338        IF IN EYES: Rinse cautiously with water for several minutes. Remove    
    contact lenses, if present and easy to do. Continue rinsing.
    P310        Immediately call a POISON CENTER or doctor/ physician.    
    Supplemental Hazard information (EU)
    EUH014        Reacts violently with water.    
  Other hazards - none

---

SECTION 3: Composition/information on ingredients
  Substances
    Formula        : C10H8ClNO4S    
    Molecular Weight        : 273,69 g/mol    
    CAS-No.        : 4403-36-5    
  Hazardous ingredients according to Regulation (EC) No 1272/2008
    Component        Classification        Concentration    
  2-Phthalimidoethanesulfonyl chloride
    CAS-No.        4403-36-5        Skin Corr. 1B; , H314,        <= 100 %    
    EUH014
    For the full text of the H-Statements and R-Phrases mentioned in this Section, see Section 16

---

SECTION 4: First aid measures
  Description of first aid measures
  General advice
    Consult a physician. Show this safety data sheet to the doctor in attendance.
  If inhaled
    If breathed in, move person into fresh air. If not breathing, give artificial respiration. Consult a physician.
  In case of skin contact
    Take off contaminated clothing and shoes immediately. Wash off with soap and plenty of water. Consult a
    physician.
  In case of eye contact
    Rinse thoroughly with plenty of water for at least 15 minutes and consult a physician.
  If swallowed
    Do NOT induce vomiting. Never give anything by mouth to an unconscious person. Rinse mouth with
    water. Consult a physician.
  Most important symptoms and effects, both acute and delayed
    The most important known symptoms and effects are described in the labelling (see section 2.2) and/or in
    section 11
  Indication of any immediate medical attention and special treatment needed
    no data available

---

SECTION 5: Firefighting measures
  Extinguishing media
  Suitable extinguishing media
    Dry powder
  Special hazards arising from the substance or mixture
    no data available
  Advice for firefighters
    Wear self contained breathing apparatus for fire fighting if necessary.
  Further information
    no data available

---

SECTION 6: Accidental release measures
  Personal precautions, protective equipment and emergency procedures
    Use personal protective equipment. Avoid dust formation. Avoid breathing vapours, mist or gas. Ensure
    adequate ventilation. Evacuate personnel to safe areas. Avoid breathing dust.
    For personal protection see section 8.
  Environmental precautions
    Do not let product enter drains.
  Methods and materials for containment and cleaning up
    Pick up and arrange disposal without creating dust. Sweep up and shovel. Do not flush with water. Keep
    in suitable, closed containers for disposal.
  Reference to other sections
    For disposal see section 13.

---

SECTION 7: Handling and storage
  Precautions for safe handling
    Avoid formation of dust and aerosols.
    Provide appropriate exhaust ventilation at places where dust is formed.
    For precautions see section 2.2.
  Conditions for safe storage, including any incompatibilities
    Store in cool place. Keep container tightly closed in a dry and well-ventilated place.
    Never allow product to get in contact with water during storage.
    Recommended storage temperature: 2 - 8 °C
    Handle and store under inert gas. Moisture sensitive.
  Specific end use(s)
    A part from the uses mentioned in section 1.2 no other specific uses are stipulated

---

SECTION 8: Exposure controls/personal protection
  Control parameters
  Components with workplace control parameters
  Exposure controls
  Appropriate engineering controls
    Handle in accordance with good industrial hygiene and safety practice. Wash hands before breaks and
    at the end of workday.
  Personal protective equipment
  Eye/face protection
    Face shield and safety glasses Use equipment for eye protection tested and approved under
    appropriate government standards such as NIOSH (US) or EN 166(EU).
  Skin protection
    Handle with gloves. Gloves must be inspected prior to use. Use proper glove removal technique
    (without touching glove's outer surface) to avoid skin contact with this product. Dispose of
    contaminated gloves after use in accordance with applicable laws and good laboratory practices.
    Wash and dry hands.
    The selected protective gloves have to satisfy the specifications of EU Directive 89/686/EEC and
    the standard EN 374 derived from it.
  Body Protection
    Complete suit protecting against chemicals, Flame retardant protective clothing, The type of
    protective equipment must be selected according to the concentration and amount of the
    dangerous substance at the specific workplace.
  Respiratory protection
    Where risk assessment shows air-purifying respirators are appropriate use a full-face particle
    respirator type N100 (US) or type P3 (EN 143) respirator cartridges as a backup to engineering
    controls. If the respirator is the sole means of protection, use a full-face supplied air respirator. Use
    respirators and components tested and approved under appropriate government standards such
    as NIOSH (US) or CEN (EU).
  Control of environmental exposure
    Do not let product enter drains.

---

SECTION 9: Physical and chemical properties
  Information on basic physical and chemical properties
    a) Appearance        Form: solid    
    Colour: white, off-white
    b) Odour        no data available    
    c) Odour Threshold        no data available    
    d) pH        no data available    
    e) Melting point/freezing        no data available    
    point
    f) Initial boiling point and no data available
    boiling range
    g) Flash point        no data available    
    h) Evapouration rate        no data available    
    i) Flammability (solid, gas) no data available
    j) Upper/lower        no data available    
    flammability or
    explosive limits
    k) Vapour pressure        no data available    
    l) Vapour density        no data available    
    m) Relative density        no data available    
    n) Water solubility        no data available    
    o) Partition coefficient: n- no data available
    octanol/water
    p) Auto-ignition        no data available    
    temperature
    q) Decomposition        no data available    
    temperature
    r) Viscosity        no data available    
    s) Explosive properties        no data available    
    t) Oxidizing properties        no data available    
  Other safety information
    no data available

---

SECTION 10: Stability and reactivity
  Reactivity
    no data available
  Chemical stability
    Stable under recommended storage conditions.
  Possibility of hazardous reactions
    Reacts violently with water.
  Conditions to avoid
    Exposure to moisture.
  Incompatible materials
    Strong oxidizing agents
  Hazardous decomposition products
    Other decomposition products - no data available
    In the event of fire: see section 5

---

SECTION 11: Toxicological information
  Information on toxicological effects
  Acute toxicity
    no data available
  Skin corrosion/irritation
    no data available
  Serious eye damage/eye irritation
    no data available
  Respiratory or skin sensitisation
    no data available
  Germ cell mutagenicity
    no data available
  Carcinogenicity
    IARC:        No component of this product present at levels greater than or equal to 0.1% is identified as    
    probable, possible or confirmed human carcinogen by IARC.
  Reproductive toxicity
    no data available
  Specific target organ toxicity - single exposure
    no data available
  Specific target organ toxicity - repeated exposure
    no data available
  Aspiration hazard
    no data available
  Additional Information
    RTECS: Not available
    burning sensation, Cough, wheezing, laryngitis, Shortness of breath, spasm, inflammation and edema of
    the larynx, spasm, inflammation and edema of the bronchi, pneumonitis, pulmonary edema, Material is
    extremely destructive to tissue of the mucous membranes and upper respiratory tract, eyes, and skin.

---

SECTION 12: Ecological information
  Toxicity
    no data available
  Persistence and degradability
    no data available
  Bioaccumulative potential
    no data available
  Mobility in soil
    no data available
  Results of PBT and vPvB assessment
    PBT/vPvB assessment not available as chemical safety assessment not required/not conducted
  Other adverse effects
    no data available

---

SECTION 13: Disposal considerations
  Waste treatment methods
  Product
    Offer surplus and non-recyclable solutions to a licensed disposal company. Dissolve or mix the material
    with a combustible solvent and burn in a chemical incinerator equipped with an afterburner and scrubber.
  Contaminated packaging
    Dispose of as unused product.

---

SECTION 14: Transport information
  UN number
    ADR/RID: 3261        IMDG: 3261        IATA: 3261    
  UN proper shipping name
    ADR/RID: CORROSIVE SOLID, ACIDIC, ORGANIC, N.O.S. (2-Phthalimidoethanesulfonyl chloride)
    IMDG: CORROSIVE SOLID, ACIDIC, ORGANIC, N.O.S. (2-Phthalimidoethanesulfonyl chloride)
    IATA:        Corrosive solid, acidic, organic, n.o.s. (2-Phthalimidoethanesulfonyl chloride)    
  Transport hazard class(es)
    ADR/RID: 8        IMDG: 8        IATA: 8    
  Packaging group
    ADR/RID: II        IMDG: II        IATA: II    
  Environmental hazards
    ADR/RID: no        IMDG Marine pollutant: no        IATA: no    
  Special precautions for user
    no data available

---

SECTION 15: Regulatory information
    This safety datasheet complies with the requirements of Regulation (EC) No. 1907/2006.
  Safety, health and environmental regulations/legislation specific for the substance or mixture
    no data available
  Chemical Safety Assessment
    For this product a chemical safety assessment was not carried out

---

SECTION 16: Other information
  Full text of H-Statements referred to under sections 2 and 3.
    EUH014        Reacts violently with water.    
    H314        Causes severe skin burns and eye damage.    
    Skin Corr.        Skin corrosion    
  Full text of R-phrases referred to under sections 2 and 3
    R34 Causes burns.
  Further information
    Copyright 2013 Co. LLC. License granted to make unlimited paper copies for internal use
    only.
    The above information is believed to be correct but does not purport to be all inclusive and shall be
    used only as a guide. The information in this document is based on the present state of our knowledge
    and is applicable to the product with regard to appropriate safety precautions. It does not represent any
    guarantee of the properties of the product. Corporation and its Affiliates shall not be held
    liable for any damage resulting from handling or from contact with the above product. See
     and/or the reverse side of invoice or packing slip for additional terms and conditions of sale.